Sauer System T-Slot heads and anvils, known throughout the industry as “Sauer Heads” or “Sauer Attachments”, allow for a flexible system of rotary die cutting on printer-slotters and flexo folder-gluers. Common applications include hand holes, vent holes, tear tape cuts, and five panel folders. Custom designed aluminum dies are also available and T-Slot heads can also be used to hold wood dies.

Quick set-ups are assured by Sauer System’s Kam-Lok mechanism which provides easy installation, removal, and repositioning of the heads. Heads can be installed or removed in a matter of minutes and loosened for repositioning on the shaft with a quarter turn of a locking screw.

Most T-Slot heads are made from heat treated aluminum. Where weight is not a significant factor, cast iron is used. T-Slot heads are index stamped to match existing slotter heads on the shaft for quick set-up of holders.

Sauer System anvils are made from heat treated aluminum. Anvils are available in a variety of widths and can butt flush against one another to create a wider anvil surface. With combinations of anvil available, there is virtually no job limitation due to size restrictions.


T-Slot-HeadT-Slot Head

AnvilAnvil

Typical-Arragement-for-Hand-Hole-CuttingTypical Arrangement for Hand Hole Cutting


Hand-hole-holderHand Hole Holder

Tear-tape-holderTear Tape Holder

V-cut-holderV-Cut Holder

Vent-hole-holderVent Hole Holder

 

More…


Slotter Heads and Trim Knife Hubs < – > Scrap Chopping System

Back to Sauer Systems